CONCRETE Products

Apply two coats by roller or brush onto clean, dry and sealed surface.

• For concrete and plaster, wash surface with water under high pressure, let dry, then apply one thin coat of WALL PRIMER (<50 pm).
• If the old coating and/or its substrate have blisters or other defects, then old coating removal must be done by mechanical means or by stripping with Paint Remover. On powder old coatings, apply 1 coat CLEAR BINDER.
• If substrate shows presence of fungi or algae, please proceed with the following surface preparations:
  
Apply fungicidal wash by roller and leave to react for 12h minimum. Rinse with high pressure water again. Brush if necessary. Once dried, apply a coat of fungicidal treatment on the surface which will be coated the same day. Apply a thin coat of CLEAR BINDER where necessary and leave to dry for 3h minimum. Apply 2 coats of POLYTOP paint, leaving each coat to dry 3h minimum.