WOOD Products

Tools:
High quality synthetic brush.
10 mm (3/8 inch) Medium pile synthetic roller (Polyamide or Polyester).

Facing the light and starting opposite the door so as to work towards it, apply a first even and generous coat of VEGAFLOOR®. Always maintain a wet edge to avoid overlaps.
Start with a brush at the edges, then do the remaining surface with a roller, working in areas of 2 m by 2 m.
Do 3 criss-cross passes in one application.
Allow to dry for 4 hours depending on the ambient conditions.
Sand floor (grit No. 150 to 180) to dull the surface and aid adhesion of the 2nd coat.
Apply 2nd coat of VEGAFLOOR®. Do not leave more than 12 hours between application of the 1st and 2nd coat.

• Surfaces must be dry, clean, free of dirt, grease and other surface contamination including previous coatings.
• VEGAFLOOR® can only be applied to bare wood surfaces or wood surfaces previously finished with VEGAFLOOR® or a solvent or waterborne floor varnish in good condition.
• ALL other finishes MUST be completely and thoroughly removed.
• Always clean meticulously with a vacuum cleaner after each sanding, including any dust traps (skirting, radiators, pipes, window sills, etc).
• Sand wooden floor using appropriate system and abrasive grades, depending on condition of surface and wood species.
• Cracks of 2 mm wide or less should be filled with LIANFLOOR®* and sanding resumed with 80 or 100 grit paper depending on the last grit used.
• Finish with finishing grade up to grit No. 120 or 150 depending on the wood species and thickness of wear layer.